Designed to accompany the Aggressor airbox cover, but can create a wicked look all by itself as well. With its aggressive lines and raised spine it creates a sinister style. The lower edge of this fender was designed to follow tire radius and the back is cut away to give that sinister look. This fender was engineered to give your Harley a clean look with a custom recessed LED taillight strip to replace your OEM taillight. This fender will accommodate suspension lowering kits of any kind. This fender will fit the 2007-2011 VRSC models except the VRSCR Street-Rod. It can accommodate tire widths up to 330mm but is ideal for 300mm and smaller tires. The installation of this fender requires full removal of inner fender. Your OEM Harley seat will fit and flow over this fender perfectly. If you are looking to run your sissy bar and base plate, this fender will accommodate but the aggressive curve with leave a small gap at the rear tip of the base plate.
All of our parts are made of high quality, hand laid fiberglass. We start with a high quality vinyl ester tooling gel coat to obtain maximum surface strength and durability. A surface veil is then laid into the mold and allowed to cure. This eliminates ALL chances of any bridging and blisters and fiber printing through your paint work. Our parts are built using a vinyl ester resin for optimum strength and durability. The resin is resistant to gasoline, acids, and has a higher heat distortion temperature. Each one of our parts is superior quality and 100% inspected thoroughly.